Atlas Copco HiLight V2+ User Manual

- 7 -
SAFETY PRECAUTIONS
DESCRIPTION OF SAFETY SYMBOLS USED
IN THE MANUAL
SAFETY BEFORE USE
1. Make sure that the area available for the machine
is clean and level with the ground. This will
decrease risk of injury to personnel.
2. Make sure that there is a minimum distance of
1000mm around the machine.
3. Always drain the water collected in the frame of
the light tower.
4. Make sure that the area above the light tower is
clear of blockages.
5. Make sure that the tires, lights, protective lamp
covers, electrical wiring, and the engine are not
worn out or damaged.
SAFETY DURING USE
Light tower safety
• While raising or lowering the light tower mast,
make sure the area behind it is clear of people. If
the winch or the mast malfunction, stand away
from the light tower and contact Atlas Copco.
• Do not raise, lower, or move the light tower trailer
while it is in operation.
• The light tower must be in the lowest position if it
is not in operation or if there are high velocity winds
Engine safety
• To prevent explosion, do these steps:
- Keep flammable items away from sparks and
open flames.
- Do not smoke near the engine.
- Always stop the engine before filling or
draining the fuel tank.
- Do not use flammable solvents to clean parts.
• To prevent suffocation, do these steps:
- Operate the engine in an area with good
airflow.
- Stand away from the engine exhaust pipe.
- Do the engine maintenance in an area with
good airflow.
- Fill or drain the fuel tank in an area with good
airflow.
It tells the user about a risk or a
dangerous procedure that can cause
death.
It tells the user about a risk or a
dangerous procedure that can cause
injury to personnel or damage to
equipment.
It gives precautions that must be obeyed
for a process. It also gives the operator
information about a process.
Before using the HiLight V2+, HiLight
V3+, or HiLight P2+, read the
instruction manual carefully. Obey all
instructions given in the manual.
Incorrect use of equipment can cause
injury or death.
The light tower has moving parts.
Moving parts can cut or crush body
parts.
If the light tower touches the overhead
electrical power lines, it cause injury or
death.
Do not use damaged equipment. It can
cause injury or death.
Falling equipment can cause injury or
death.
Explosion can cause injury or death.
Engine exhaust and fuel fumes can cause
breathing problems and death by
suffocation.

Atlas Copco HiLight V2+ Specifications

General

Brand	Atlas Copco
Model	HiLight V2+
Category	Lighting Equipment
Language	English