Operating on slopes
WARNING Slope hazards
During operation, secure the machine so it can not
fall if it is placed on a sloping ground. A fall can lead
to severe accidents and result in personal injury.
► Always ensure that all personnel in the working
area are higher up the slope than the machine.
► Always operate the machine straight up and down
when placed on slopes.
► Never exceed the maximum recommended slope
angle when operating the machine. Follow the
recommendations.
NOTICE Remember that loose ground, vibration
switched ON, and driving speed can all cause the
machine to tip over even on a lesser slope than
specified here.
Operating on slopes
♦
Ensure that the work area is secure. Wet and
loose earth reduces manoeuvrability especially
on sloping ground. Always exercise extreme
caution on sloping and uneven terrain.
♦
Never work on slopes that exceed the capabilities
of the machine. The maximum slope of the
machine in operation is 20° (depending on the
condition of the ground).
♦
The tilting angle is measured on a hard level
surface with the machine stationary. Vibration
switched OFF and all tanks full.
Start and stop
Before starting, Honda
Follow the general safety precautions supplied with
the machine at delivery. We recommend to study the
engine manual supplied with the machine. Check
that maintenance routines have been carried out.
© 2015 Construction Tools EOOD | No. 9800 1117 01c | 2015-05-20
Original instructions
16
LF 50Safety and operating instructions
To Next Page
Loading...
