CAUTION Cover the V-belt
Running a machine without the protective cover over
the V-belt may cause trapping or machine damage,
which can cause injury.
► Never run the machine without the protective cover
over the V-belt.
► Stop the engine before removing the protective
cover.
Checking the V-belt
The V-belt must be checked and adjusted by
authorized service personnel.
1. Remove the protective cover (A).
2. Check if the V-belt (B) is damaged, change if
necessary.
3. If the V-belt tension needs adjusting, loosen the
four engine-plate bolts and slide the engine
backwards.
4. Check that the V-belt pulleys are in line, tighten
the screws and reinstall the protective cover (A).
Checking the shock absorbers
1. Check all the shock absorbers (A) for cracks or
if they are exhausted. There are two shock
absorbers (A) on each side of the machine.
2. Change the shock absorbers (A) if they are
damaged.
Checking spark plug, Honda
♦
Check, clean and replace the spark plug.
Every 500 hours of operation
(yearly)
Maintenance routines:
♦
Adjust valve clearance for intake and exhaust
valves. See engine manual for more information.
© 2015 Construction Tools EOOD | No. 9800 1117 01c | 2015-05-20
Original instructions
22
LF 50Safety and operating instructions
To Next Page
Loading...
