Atlas Copco LF 50

Stopping the engine, Honda
1. Move the throttle control to idling position (A).
Let the engine idle for a few minutes.
2. Turn the start switch (B) to OFF.
3. Close the fuel cock (C).
Operating
NOTICE Always operate the machine at full speed,
otherwise it prevents the eccentric element from
compacting correctly. It can result in machine failure.
Handle positions
NOTICE Always operate the machine forwards,
otherwise it opposes the force of the eccentric
element which works in a forward direction. Turn the
machine around to prevent machine failure.
Raise the handle to the operating position:
1. Loosen the knobs (A).
2. Raise the handle from the folded position.
3. Tighten the knobs when the upper handle (B) is
in the correct position.
A
B
Fold the handle to the transport position:
1. Loosen the knobs (A) and lower the handle on
top of the machine.
2. Tighten the knobs.
A
19© 2015 Construction Tools EOOD | No. 9800 1117 01c | 2015-05-20
Original instructions
Safety and operating instructionsLF 50