Power Focus 4000 EN Installation
© Atlas Copco Industrial Technique AB - 9839 001800 00
9
Installation
Installation
Installation procedure
1. Mount the controller on the wall or steel plate with four M6 screw. If
mounting on a wall, make sure to use correct wall bracket (plug and screw).
If mounting on a steel plate, make sure that the thickness of the plate is min-
imum 2 mm.
2. Open the locking mechanism
3. Open the controller slowly towards you, not to cause injury or damage
4. Connect the tool cable, power cable etc.
5. Connect the RBU
6. Close the controller and lock it
7. Connect the power cable to a power supply (115/230 V)
8. Turn the power on
To Next Page
Loading...
