Atlas Copco Power Focus 4000

Getting started with ToolsTalk PF
9836 3123 01 63 (428)
6.3 Configuring ToolsTalk settings
This section describes some of the available ToolsTalk settings. The following settings are located in the
Settings dialog box. The settings are configurable off-line.
 Setup for communication with PF
 Setup for viewing information inside the ToolsTalk PF application
 Printout setup
 Administration of the PF list
On the menu bar, open Options>Settings.
6.3.1 Communication
The Communication tab has four areas; View event setup, Serial setup, Ethernet setup and LOG.
In the View event setup area, make selections for viewing controller errors and warnings.