Pset
90 (428) 9836 3123 01
7.6.9 Yield control (Yield)
Yield control is activated by selecting the P100 Control strategy to Yield. The P101 Tightening strategy can be
set to One stage, Two stage or Quickstep. Yield control interacts in the second stage of the tightening. P105
Zoom step strategy ending is eliminated when yield control is selected.
The settings for Yield are found under Programming+. For more information, see Yield control in section
Programming+.
7.6.10 Yield/Tq con (OR)
Select Yield/Tq con (OR) in P100
Control strategy.
In addition to the settings for Yield
(see Yield control in section
Programming+) a final target is
set. The tool stops when P113 Final
target is reached if the yield
function has not stopped the tool
before.
To Next Page
Loading...
