EN Power Focus 600
10
© Atlas Copco Industrial Technique AB - 9836 4954 01
Tool menu
The Tool menu has functions related to the tool con-
nected to the controller. Here the user can access in-
formation about the connected tool, perform tool cali-
bration, motor tuning, and set up tool maintenance.
Controller menu
On the Controller menu the user can administer and
install new controller software, view information
about the hardware devices installed on the controller,
and export or import configurations and reports.
Accessories menu
On the Accessories menu the user can configure the
internal I/Os and the hardware accessories that can be
used with the controller such as I/O Expander, Stack-
light, Operator Panel and Socket Selector. The Scan-
ner is configured on the Batch menu.
Note! The controller must be equipped with a Station con-
trol IAM to be able to connect to, and configure ac-
cessories.
Reports menu
On the Reports menu the tightening results, events,
and NOK ratio are available. Depending on IAM type
the number of stored tightening results may vary.
Settings menu
The Settings menu contains settings for to set up the
controller on a LAN, PIN, language, date and time,
torque unit to be used, as well as how to display the
results.
Help menu
The Help menu contains useful help sections about
the controller. The footer on the controller display
also shows relevant help to functions on the con-
troller.
Setup
For instructions on how to mount and connect the Power Focus 600 controller,
refer to the Product instructions (9836 5795 00).
To Next Page
Loading...
