Atlas Copco Power Focus 600 - TurboTight; Quick Step; Rotate

EN Power Focus 600
28
© Atlas Copco Industrial Technique AB - 9836 4954 01
Parameter Description Default value
Strategy Available tightening strategies.
TurboTight: No additional tight-
ening behavior will be used as de-
fault. Only target values will be
used.
Quick step: Adds an initial tight-
ening step to reduce preload scat-
ter.
Two step: Adds a pause between
the first and final tightening step to
further counteract short-term relax-
ation effects.
Three step: Tightens to a defined
First torque value, then loosens the
bolt and immediately retightens it
to Target torque.
Rotate: Rotates the spindle a spec-
ified speed and angle.
TurboTight
Target torque Defines the target torque of the
tightening or final step.
Target torque Defines the target torque of the
tightening or final step.
{ , : noprofile in element [entry]}
{ , : noprofile in element [p]}5%
of Tool max torque
Target angle Defines the target angle of the
tightening or final step.
Target speed Activates setting the tool speed for
the final step manually or using the
default speed.
Auto: Uses a default value based
on the Tool max speed.
Manual: Specify the tool speed
manually.
Auto
<Manual> Tool speed during tightening. If a
first step is added this corresponds
to the speed of the final step.
TurboTight
TurboTight is the default tightening strategy and it is designed to perform a
very fast and ergonomic tightening based on the tool’s maximum speed (Tool
max speed). This strategy requires only the Target torque to be set to perform
the tightening. Depending on the joint properties, for example if the joint is
very stiff or very soft, a different tightening strategy might be needed.
Note! The TurboTight strategy is only available when using
the Tensor STR tools.