Atlas Copco Power Focus 600 - Page 43

Power Focus 600 EN
© Atlas Copco Industrial Technique AB - 9836 4954 01
43
Code Input signal Description PF6000 PF600
Lock tool The tool locks when
this signal is given.
Select input bit 0
Select input bit 1
Select input bit 2
Select input bit 3
Bit bistable relay
Reset bistable relay
Manual mode
Line switch 1/In
Line switch 2/Out
Start tightening Starts the tool in the
specified tightening
direction. Tool start
input source must be
set to DigIn.
Start loosening Starts the tool in the
specified loosening
direction. Tool start
input source must be
set to DigIn.
Tightening pulse
start
Tightening pulse
stop
Start drive
Select loosening
Line control start Input signal to start
the Line control
function.
Line control send
alert 1
Line control send
alert 2
Use alternative iden-
tifier
External monitored 1
External monitored 2
External monitored 3
External monitored 4
External monitored 5
External monitored 6
External monitored 7
External monitored 8
Test input signal