- 11 -
Operating Manual SUNTEST
®
CPS+
2.3 Installation requirements
Climatic conditions required for the place of instal-
lation:
• During continuous operation, the hot air emitted by the
air-cooling system results in a constantly changing cli-
mate in the room. Therefore, the SUNTEST instrument
should only be installed in air-conditioned, sufciently
ventilated areas.
• The room temperature must be maintained between
18° C and 25° C.
• The maximum relative humidity should be 50%
(+/- 10%).
The requirement for cooled air is as follows:
• 150 m³/h each for lamp cooling and cooling of the test
chamber.
2
Installation of the instrument
2.4 Installation of the instrument
Installation of thr SUNTEST CPS+:
• Dimensions of the instrument (width x depth x height):
780 mm x 350 mm x 350 mm,
• Weight of the instrument: approx. 30 kg,
• Stand the instrument on a sufciently stable, horizontal
laboratory bench.
Caution – overheating of the instrument
The instrument will overheat and be damaged
if the air inlet and outlet are obstructed!
Keep the following minimum distances away
from adjacent walls or objects for installation.
• Keep the top of the instrument free; do not place objects
on the instrument.
• At the back of the instrument 30 cm.
• At the left and right hand sides of the instrument 10 cm.
• Mutual inuences of the supply and exhaust air must
be prevented when installing several instruments.
NOTE – Transport
The instrument may only be transported by experienced
service personnel with suitable equipment.
To Next Page
Loading...
Need help?
General
