Atmos C 31 - Changing the Halogen Bulb of the Counter-Mirror Lamp; Changing the Rinsing Container

35
Fig. 39. Changing the rinsing container
6.6 Changing the rinsing container
 Please switch off the unit before removing the rinsing
container.
 To replace the rinsing container, push it all the way up and
swing it out together with the level switch. The container
must be lifted over the edge of the holder.
 The container can then be withdrawn obliquely down-wards
and outwards.
 To insert the container, swing the level switch upwards.
The container is pushed obliquely upwards to the stop,
swung over the edge of the holder and pushed down into
theinsert(seeg.39).
6.5 Changing the halogen bulb of the
counter-mirror lamp
 Allow the lamp to cool down before changing it!
 Pull out the plug of the halogen counter-mirror lamp.
 The halogen bulb is located under two glass disks, which
are held with a snap ring.
 To release the snap ring insert a small screwdriver under
the nose of the snap ring and lift it out.
 Lift out the two glass disks.
 Removethereectorofthehalogenlamp.
 When you insert the new lamp make sure that you do not
touchthereectorwithyourbarengersbutuseaclean
cloth.
6.0 Maintenance and servicing