Atomos SHOGUN User Manual

*Subject to change without notice Atomos Shogun – User Manual Edition 2: January 2016 33
LTC
If LTC is selected then Timecode will be taken in via the LTC input. If no
LTC signal is present the following icon is displayed and the unit
will revert to SDI/HDMI Timecode
Please note that the LTC generator needs to be set to the same frame
rate as the input video signal. If the LTC signal is looped through
to the other channel then both recordings will have synchronized
Timecode.
Record Run
WiththissettingyousetthestartingTimecodefortherstclip.The
following clips will start at the frame immediately after the out point of the
preceding clip. This will continue for all clips that follow. This is also
known as continuous Timecode.
Auto Restart
With this setting, the Timecode will be reset to the Timecode you have
denedwheneveryoupressrecord.Allyourclipswillstartwiththissame
Timecode.
To adjust the Timecode use the “+” and “-” above and below the
hour:minute:seconds sections
9. Timecode cont.

Atomos SHOGUN Specifications

General

Display resolution	1920 x 1200 pixels
HDD size	2.5 \
HDD interface	Serial ATA
Power consumption (typical)	20 W
Product color	Black

Weight and Dimensions

Weight	732 g
Dimensions (WxDxH)	196 x 47 x 110 mm