46
indicator light will only disappear after all alarms are cleared (currently no
alarms), as shown in the following figure:
Alarm not cleared Alarm cleared
3.2 Solutions to the warning
Once the equipment is alarmed, the user must stop using the handheld laser
welding equipment immediately and troubleshoot the fault. Use it only after the
fault is solved. Users can refer to the alarm information in the alarm window
to troubleshoot faults. The alarm information and solutions are shown in the
following table:
Alarm Err-E001: The
controller is not
connected!
Check whether the RS485
communication line between the
touch screen and the controller
is properly connected, and check
whether the controller is
normally powered on and started.
Alarm Err-B001: The
air pressure is too low!
Check whether the air
pressure is normal.
Alarm Err-L001: Laser
failure!
Check whether the laser is
working properly.
Alarm Err-W001：
Welding head communication
failure!
Check whether the
connection between the welding
head and the controller is
correct and the welding head
screen has a picture.
To Next Page
Loading...