60
wire out of the wire guide tube interface of the wire filling machine, insert it into the inlet end of the
wire feed tube, and tighten the nut at the inlet end of the wire feed tube to the wire feeder.
5、Disassemble the wire filling nozzle on the wire feeding tube.
6、Press the spot wire feed switch on the panel/press the welding gun switch to send the welding
wire out from the outlet of the wire filling gun.
7、Pass the welding wire through the wire filling nozzle, and reinstall the wire filling nozzle onto the
wire filling gun barrel.
8、Fix the wire filling gun on the welding gun by connecting the fixed bracket, and adjust the wire
feeding angle so that the welding wire is aligned with the position of the molten pool.
6. Routine maintenance
1. When not in use, the wire filling machine should be placed stably in a cool, dry place and away from
dust;
2. Do not place other objects on the wire filling machine to avoid damage, collision, or falling;
3. Before installing a new wire reel, use compressed air to blow the inside of the wire tube to remove
impurities inside the wire tube;
4. Keep the wire guide tube smooth and the tube cannot be squeezed, deformed, or folded;
5.Clean the dust inside the machine regularly, check the smooth rotation and the noise of the motor.
To Previous Page
Loading...