Audi A4 2015 - Page 62

Vehicles with 4-cyl. TDI engine:
– Remove bolts -2 … 5- securing gearbox to engine (accessible
from above).
All vehicles:
– Remove propshaft ⇒ Rear final drive; Rep. gr. 39 ; Propshaft;
Removing and installing propshaft .
– Detach intermediate steering shaft from steering rack and
slide together ⇒ Running gear, axles, steering; Rep. gr. 48 ;
Steering column; Removing and installing intermediate steer‐
ing shaft .
– Remove bolts -arrows- securing coolant pipe for gearbox.
– Clamp off coolant hoses using hose clamps (up to 25 mm) -
3094- , release hose clips -1 and 2- and disconnect hoses.
– Support engine in installation position ⇒ Rep. gr. 10 ; As‐
sembly mountings; Supporting engine in installation position .
– Remove front wheels ⇒ Running gear, axles, steering; Rep.
gr. 44 ; Wheels, tyres .
– Remove drive shaft cover on both sides ⇒ General body re‐
pairs, exterior; Rep. gr. 66 ; Wheel housing liners; Exploded
view - wheel housing liner (front) .
– Remove subframe shield -arrow- (below drive shaft on left
side) ⇒ Running gear, axles, steering; Rep. gr. 40 ; Subframe;
Exploded view - subframe .
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
58 Rep. gr.34 - Controls, housing