Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
- Use keypad -2- to enter "33" for "Adaption channel 33" and confirm by touching Q key.
-> Readout on VAS 5051:
1 - Channel 33
Read and test
4 - Slide bar positioned on current adaption value 128
Notes:
◆ The adaption value 128 corresponds to the factory-set value.
◆ The adaption can be changed between 112 ... 144.
◆ Dash panel insert replacement => Page 67 .
- Use slide bar to change adaption value =>"A - Changing adaption value with slide bar", Page 31 .
Or
- Change adaption value by means of direct entry => "B - Changing adaption value by means of direct entry",
Page 32 .
- Enter 5-digit adaption value. Use "0" to fill up blanks.
Example:
Desired input: 134
Keypad entry: 00134
Note:
Fault message "Function unknown or cannot be implemented at present" appears if an implausible value is
entered.
Audi A8 1994 ➤
Electrical system Self-diagnosis 02.99 ➤ - Edition 05.2002
1.13 - Adaption channels 18 to 33 47
To Next Page
Loading...
