Audio Technica AT-LP60XBT User Manual

1. Mount the new replacement stylus to the cartridge.
2. Lift the stylus up until you hear a click.
3. Make sure there is no gap between the headshell and the cartridge.
Replacing the belt
The belt is a consumable part. Replace the belt if the speed of playback slows down or irregular rotation occurs.
As a rule of thumb, we suggest replacing the belt once a year.
Before replacing the belt, be sure to disconnect the product’s AC adapter from the outlet.
1. Remove the felt mat.
2. Remove the platter, turn the platter over, and then remove the old belt.
Place your thumbs in the openings and pull up strongly.
3. Place the new belt around the inner circle.
Be careful not to twist the belt while doing this.

Audio Technica AT-LP60XBT Specifications

General

Type	Belt-drive audio turntable
Operation	Fully automatic
Motor type	DC servo motor
Drive system	V-belt
Output level	150 mV
Product color	Black
Wow & flutter	0.25 %
Nominal speeds	33 1/3, 45 RPM
Platter material	Aluminum
Built-in phono preamplifier	Yes
Signal-to-Noise Ratio (SNR)	50 dB
Power supply type	AC
AC adapter frequency	50/60 Hz
AC adapter input voltage	115/230 V
Quantity	1
Cables included	Audio (3.5mm)
USB ports quantity	0

Weight and Dimensions

Depth	373.3 mm
Width	359.5 mm
Height	97.5 mm
Weight	2600 g