Audio Technica AT-LP60XBT User Manual

Playing a record
Before playing a record
1. Remove the cartridge’s protector.
Pull the protector straight forward to remove it.
Applying a downward force may cause the stylus to come off the body. Only low volume is output if the
stylus has come off, or is about to come off, so refer to “Replacing the stylus” on p. 10 to reattach the
stylus correctly.
2. Place the record on the felt mat so that the center hole aligns with the spindle.
If playing a 45 RPM record with a large center hole, attach the 45 RPM adapter (see the right side of the
diagram below).
Automatic operation
Lower the volume of the amplifier, speakers, etc. sufficiently.

Audio Technica AT-LP60XBT Specifications

General

Type	Belt-drive audio turntable
Operation	Fully automatic
Motor type	DC servo motor
Drive system	V-belt
Output level	150 mV
Product color	Black
Wow & flutter	0.25 %
Nominal speeds	33 1/3, 45 RPM
Platter material	Aluminum
Built-in phono preamplifier	Yes
Signal-to-Noise Ratio (SNR)	50 dB
Power supply type	AC
AC adapter frequency	50/60 Hz
AC adapter input voltage	115/230 V
Quantity	1
Cables included	Audio (3.5mm)
USB ports quantity	0

Weight and Dimensions

Depth	373.3 mm
Width	359.5 mm
Height	97.5 mm
Weight	2600 g