2. Turn the counterweight and the tracking force gauge ring together counterclockwise from the 0 position (to the
left) until the centerline value matches the recommended tracking force value for the cartridge you are using.
Refer to the cartridge maker’s specifications for the recommended tracking force value.The tracking force
value for the cartridge provided with this product is 2.0 g.
Setting the anti-skate adjustment While the record is playing, a force acts on the stylus tip to pull it inward. This
force can be counteracted by setting the same values for anti-skate and the tracking force.
1. Adjust the anti-skate control dial to have the same value as the tracking force value.
The tracking force value for the cartridge provided with this product is 2.0 g.
Preparation for use
Installing/removing the dust cover When attaching the dust cover, insert the hinges of the dust cover into the
two dust cover hinge holders on the back of the body. When removing the dust cover, slowly pull the dust cover
out from the dust cover hinge holders.
Setting output selector switch This product has a built-in phono equalizer function. You can use the product,
even if you do not have a phono amplifier or connectable equipment with a built-in phono amplifier, by connecting
an active speaker, etc. Use the output selector switch to set the output, as shown below.
To Next Page
Loading...
Need help?
General
