AudioCodes Mediant 3000

Hardware Installation Manual 38 Document #: LTRT-94720
Mediant 3000
3.8 Power Supply
The device can be powered from one of the following power sources (depending on
customer order):

AC power source (see Section 3.8.1 on page 39)

DC power source (see Section 3.8.2 on page 42)
The power supply units provide the following features:

Load-sharing to provide necessary voltages and fail-safe operation - active current
load sharing on positive outputs (V1, V2)

Integral LED status indicators

Hot-pluggable connector, with staged pin lengths

Hot swappable

Optimized thermal management

Control and monitoring features
Note: If you want to change the device's power system (i.e., AC to DC, or DC to AC),
you need to change the chassis. For more information, contact your AudioCodes
representative.