AudioCodes Mediant 3000

Version 7.0 65 Mediant 3000
Hardware Installation Manual 5. Cabling the Device
 To cable the PEM modules for BITS synchronization mode:
1. Connect the Trunk from BITS source A to the RJ-48 port (labeled BITS/SETS), located
on the lower PEM module (A).
2. Connect the Trunk from BITS source B to the RJ-48 port (labeled BITS/SETS), located
on the upper PEM module (B).
Figure 5-14: Connecting BITS Trunk Sources on PEM
Legend Description
1
Connects trunk from BITS Source A
2
Connects trunk from BITS Source B
3
Lower PEM #1 (A)
4
Upper PEM #2 (B)