AudioCodes Mediant Series - 4.2 Step 2: Configure a Network Interface for the Device

Configuration Note 4. Configure AudioCodes Mediant Gateway
Version 6.8 23 February 2014
4.3 Configure SIP Transport Type
The procedure below describes how to set the SIP transport type to TLS.
 To configure SIP Transport Type:
1. Open the SIP General Parameters page (Configuration tab> VoIP menu > SIP
Definitions > General Parameters).
Figure 4-3: SIP General Parameters
2. From the 'SIP Transport Type' drop-down list, select TLS.
3. In the ‘SIP Destination Port’ , enter 5061
4. Click Submit.