AudioCodes Mediant Series - Configure Trunk Group Settings; Figure 4-13: Trunk Group Configuration Trunk Group Settings

Configuration Note 4. Configure AudioCodes Mediant Gateway
Version 6.8 33 February 2014
4.10 Configure Trunk Group Settings
The procedure below describes how to configure Trunk Group settings.
 To configure Trunk Group settings:
1. Open the Trunk Group Settings page (Configuration tab> VoIP menu > GW and IP
to IP > Trunk Group > Trunk Group Settings).
2. In the 'Trunk Group ID' field, enter "1".
3. From the 'Channel Select Mode' drop-down list, select Cyclic Ascending.
4. From the 'Serving IP Group ID' drop-down list, select 1.
Figure 4-13: Trunk Group Configuration Trunk Group Settings
5. Click Submit.