AudioCodes MediaPack 124 - Unpacking the Device

MediaPack Analog Gateways 11 MP-124
Hardware Installation Manual 2. Unpacking the Device
2 Unpacking the Device
Follow the procedure below for unpacking the device.
 To unpack MP-124:
1. Open the shipping carton and carefully remove the packing materials.
2. Remove the MP-124 unit from the carton.
3. Check that there is no equipment damage.
4. Ensure that in addition to the MP-124 unit, the package contains the following items:
• MP-124 Rev. D:
♦ Only for AC-powered model: AC power cord
♦ Only for DC-powered model: unwired DC terminal block with two crimping
screws
♦ Two short equal-length brackets and bracket-to-device screws for 19-inch
rack installation.
♦ Regulatory Information document.
• MP-124 Rev. E:
♦ Two short equal-length brackets and bracket-to-device screws for 19-inch
rack installation.
♦ Regulatory Information document.
5. Check, retain and process any documents.
6. Notify AudioCodes or your local supplier of any damage or discrepancies.