52
To recall the saved information, press and hold the memory (mem.)
button for three (3) seconds and the MEMORY RECALL screen will be
displayed (see Figure 42). If there is more than one (1) entry in memory,
use the Rotary/Select Knob or the remote control UP and DOWN
buttons to scroll through all stored entries.
To exit this mode, either press the Menu button twice or Jump button
once. This mode will also time-out after 10-seconds and return to the
active screen.
Figure 42. Memory Selection Screens
Pre./Dir
The Pre./Dir button determines whether the numbered buttons 0 through
9 will operate as a keypad for entering station numbers directly, or as
presets (A, B, C) used to select stations. The unit informs the operator by
displaying the selected mode (DIRECT, PRESET A, PRESET B,
PRESET C) on the top line of the display.
To Next Page
Loading...
Need help?
General
