Audiovox Satellite Radio Receiver User Manual

3
FCC Information
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
The user is cautioned that changes or modifications not expressly approved by XM
®
Satellite Radio, Inc. can void the user’s authority to operate this device.
Please note that the cables that have been supplied with your XMC10 car cradle
are supplied with permanently attached ferrite beads. It is the responsibility of
the user to use the cable with the ferrite beads.
By adhering to these warnings and safety considerations, stated in the manual and
by XM®, accidents.

Audiovox Satellite Radio Receiver Specifications

General

Brand	Audiovox
Model	Satellite Radio Receiver
Category	Radio
Language	English