AUMA SA 07.1 - Bus Terminal Compartment: Close; Accessories for Electrical Connection; Controls Mounted to Wall Bracket

To Next Page

To Previous Page

5.2.6 Bus terminal compartment: close

Figure 22: AUMA plug/socket connector SD bus

[1] Cover

[2] Screws for cover

[3] O-ring

[4] Cable entries for bus cables

[5] Blanking plug

1. Clean sealing faces of cover [1] and housing.

2. Apply a thin film of non-acidic grease (e.g. petroleum jelly) to the sealing faces.

3. Check whether O-ring [3] is in good condition, correctly insert O-ring.

4. Fit cover [1] and fasten screws [2] evenly crosswise.

5. Fasten cable glands with the specified torque to ensure the required enclosure

protection.

5.3 Accessories for electrical connection

— Option —

5.3.1 Controls mounted to wall bracket

The wall bracket allows separate mounting of controls and actuator.

Application

●

If the actuator cannot be accessed.

●

If the actuator is subject to high temperatures.

●

In case of heavy vibration of the valve.

SA 07.1 – SA 16.1/SAR 07.1 – SAR 16.1 Control unit: electromechanic

AC 01.1 Intrusive Modbus RTU Electrical connection

Other manuals for AUMA SA 07.1