AUMA SAVEx Series - Page 103

Please state device type and our order number (see name plate) when ordering spare parts. Only original AUMA spare parts should be used.
Failure to use original spare parts voids the warranty and exempts AUMA from any liability. Representation of spare parts may slightly vary
from actual delivery.
TypeDesignationRef. no.
Sub-assemblyLocal controls002.0
Sub-assemblyLocal controls board002.3
Face plate for display002.4
I/O board008.1
Fieldbus board008.1
Sub-assemblyLogic board009.0
Sub-assemblyRelay board011.1
Power supply unit/DC link013.0
Sub-assemblyMotor controller/switchgear014.0
Sub-assemblyCover500.0
Pin carrier without pins502.0
Sub-assemblyPin for controls505.0
Sub-assemblyPin for motor506.0
Sub-assemblyPadlock509.1
Cable conduit (actuator connection)532.0
Retaining ring535.1
Ex plug/socket connector (KT, KM)628.0
Sub-assemblySwitchgear housing633.0
SetSeal kitS
103
SAVEx 07.2 – SAVEx 16.2 / SARVEx 07.2 – SARVEx 16.2 Control unit: electronic (MWG)
ACVExC 01.2 Non-Intrusive Modbus RTU Spare parts