AUMA SG 05.1-F05 - Page 3

255.3.2 Parking frame
265.3.3 Protection cover
265.3.4 Double sealed intermediate frame
265.3.5 Earth connection, external
276. Operation................................................................................................................................
276.1. Manual operation
276.1.1 Manual operation: engage
276.1.2 Manual operation: disengage
276.2. Motor operation
276.2.1 Local operation
286.2.2 Operation from REMOTE
296.3. Menu navigation via push buttons (for settings and indications)
296.3.1 Short overview: Functions of the push buttons
296.3.2 Structural design and navigation
306.4. Password entry
316.5. Language change in the display
337. Indications..............................................................................................................................
337.1. Status indications in the display
337.1.1 Status indication S0/S6 - operation
347.1.2 Torque indication: edit
347.2. Indication lights/LEDs
357.3. Mechanical position indicator/running indication
368. Signals.....................................................................................................................................
368.1. Signals via fieldbus
368.2. Feedback signals via output contacts (binary)
368.3. Feedback signals (analogue)
379. Commissioning (basic settings)...........................................................................................
379.1. Heat-up time for low temperature version
379.2. End stops in part-turn actuator
389.2.1 End stop CLOSED: set
399.2.2 End stop OPEN: set
399.3. Swing angle
409.3.1 Swing angle modification
419.4. Type of seating: check/edit for end positions
449.5. Baud rate, parity and bus addres (slave addess): set
479.6. Further parameters of the Modbus interface
479.7. Switch compartment: open
489.8. Torque switching: set
489.9. Limit switching: set
499.9.1 End position CLOSED (black section): set
499.9.2 End position OPEN (white section): set
509.10. Intermediate positions: set
509.10.1 Running direction CLOSE (black section): set
509.10.2 Running direction OPEN (white section): set
519.11. Test run
519.11.1 Direction of rotation: check
519.11.2 Limit switching: check
529.11.3 Reference operation position feedback: perform
529.12. Potentiometer setting
3
SG 05.1 – SG 12.1/SGR 05.1 – SGR 12.1 Control unit: electromechanic
AC 01.1 Intrusive Modbus RTU Table of contents