AUMA SG 05.1-F05 - Page 4

539.13. Electronic position transmitter RWG: set
539.14. Mechanical position indicator: set
549.15. Switch compartment: close
549.16. Operating time: set
5610. Corrective action....................................................................................................................
5610.1. Faults during commissioning
5610.2. Fault indications and warning indications
5610.2.1 Status indication S0 - faults and warnings
5710.2.2 Status indication S1 - faults
5810.2.3 Status indication S2 - warnings
5910.2.4 Status indication S3 - causes for not ready remote
5910.3. Fuses
5910.3.1 Fuses within the actuator controls
6010.3.2 Motor protection (thermal monitoring)
6211. Servicing and maintenance...................................................................................................
6211.1. Preventive measures for servicing and safe operation
6211.2. Maintenance
6211.3. Disposal and recycling
6312. Technical data.........................................................................................................................
6312.1. Features and functions of actuator
6412.2. Features and functions of actuator controls
6712.3. Modbus interface
6912.4. Service conditions
6912.5. Accessories
7012.6. Further information
7113. Spare parts.............................................................................................................................
7113.1. Part-turn actuators SG 05.1 – SG 12.1/SGR 05.1 – SGR 12.1
7313.2. Actuator controls AUMATIC AC 01.1 with AUMA plug/socket connector(SD bus)
7514. Certificates..............................................................................................................................
7514.1. Declaration of Incorporation and EC Declaration of Conformity
7615. Index........................................................................................................................................
78Addresses...............................................................................................................................
4
SG 05.1 – SG 12.1/SGR 05.1 – SGR 12.1 Control unit: electromechanic
Table of contents AC 01.1 Intrusive Modbus RTU