20
5
Operation
Powering MaxiCharger
Ensure all the installation and wiring are secured and correct, then power on the charger. There will be a
series of self-check starts, making sure that the charger works correctly and safely. The power LED should
illuminate green. If a recoverable error is detected or the charger is temporarily disabled by the server, the
charging LED will illuminate yellow; if the error cannot be recovered, it will illuminate red.
WARNING
Be careful when you work with electricity.
Start Charging
1. Insert the charging handle into the charge port on your EV and the charger socket outlet.
2. Choose one of the following ways to start a charging session:
—
Tap your RFID card on the RFID card reader.
—
Use the Autel Charge app by tapping Start on the Charge screen.
—
If you have set a charging schedule in the Autel Charge app, the charger will initiate a charging
session automatically as scheduled. (Scheduled charging case)
—
If the Plug-and-charge function is enabled in the Autel Charger app, the charger will automatically
start charging once the charging handle is properly connected.
NOTE
Ensure your EV is charging. The charging LED on the charger should flash green. If you suspect the vehicle is
not charging properly, try reconnecting the charging cable or contact customer support for further assistance.
Stop Charging
1. To stop charging, you can choose either of the following two ways:
Wait for the charging session to end and no further actions are required in the case of scheduled
charging or plug-and-charge.
—
The charging LED will illuminate solid green.
—
The Autel Charge app displays that your EV is fully charged.
End the charging session via the Autel Charge app or by tapping your RFID card on the RFID card
reader again.
2. Remove the charging handle from the charger socket outlet and the EV charge port.
To Next Page
Loading...
