6.4 HANDLING
The packaged lift must be handled by a transpallet, fork lift
truck, etc.
The means used for safe handling must have a load
capacity suited to the load to be transported (see weight
indicated in the Technical Data table).
HANDLING STAFF MUST WEAR: SAFETY SHOES WITH STEEL TOE
CAP AND NON-SLIP SOLES.
MAKE SURE THAT NO UNAUTHORISED PERSONS ARE STANDING
WITHIN THE RADIUS OF ACTION OF THE LIFTING/HANDLING MEANS
(FORK LIFT TRUCK, TRANSPALLET, ETC.) DURING THE LIFTING,
TRANSPORT AND HANDLING OPERATIONS.
If a cardboard box has been used for packaging, to unpack the lift, cut the cardboard packaging with a
stanley knife (max. blade length 1 cm) on the 4 sides of the base of the packaging, then lift and remove.
Otherwise, if a wooden crate has been used, remove the nails from the wooden crate starting from the
top and then remove the side walls.
STAFF REMOVING THE PACKAGING MUST WEAR: SAFETY SHOES
WITH STEEL TOE CAP AND NON-SLIP SOLES AND GLOVES.
6.5 INSTALLATION ON A VEHICLE
Installation on a vehicle must be performed exclusively by Autolift staff or authorised
installers.
Autolift declines all liability to damage to persons, property or the machine due to
installation on a vehicle not performed by authorised persons.
To Next Page
Loading...
