7.1 NORMAL USE
The AUTOLIFT SKY electro-hydraulic lift control is a wired portable remote control known as push-
button panel, equipped with two round protruding buttons indicating the two operating states.
The fundamental purpose of the push-button panel is to control the four distinct lift operations (open -
down - up - close) in just two control buttons.
This is done by a special electrical system which uses a timer-operated consent technology. Simply and
safely it prevents you from having to change button for every different lift movement and from entering
the wrong command.
Hold down the lower button (down arrow)
and the lift opens from the vertical
stowage position to rest in a horizontal
position parallel to the floor of the vehicle
it is installed on.
After opening, the lift stops automatically.
To lower the lift to the ground, press the
down arrow button again: the platform
descends slowly to the ground (the anti-
roll device lowers automatically when the
platform touches the ground).
To raise the lift, press and hold down the
button with the up arrow, in the upper part
of the push-button panel.
The anti-roll device rises automatically
when the platform lifts off the ground.
To Next Page
Loading...
