AUTOLIFT BB 1350 - Page 28

TROUBLESHOOTING
11
Lift
DEVICE
BB – SKY – BBW
MODEL
28
ANOMALY
FAULT
REMEDY
Push-button panel broken
Replace the push-button panel
Electronic control unit broken
Replace the electronic control unit
The platform descent is not properly
controlled
Lowering valve screw not tight
Close the lowering valve
Lowering valve broken
Replace the lowering valve
The platform does not rise
Lowering valve screw not tight
Close the lowering valve
Lowering valve broken
Replace the lowering valve
Electro-pump remote switch broken
Replace the electro-pump remote
switch
Electro-pump broken
Replace the electro-pump
Push-button panel broken
Replace the push-button panel
Electronic control unit broken
Replace the electronic control unit
Insufficient battery charge
Charge the battery
Dirty earth connection
Clean the earth connection
Hydraulic power unit broken
Replace the hydraulic power unit
Max. speed control at excessively
low levels
Calibrate the speed to an
appropriate level
The platform does not stop at the
loading surface when rising
Micro M1 not connected correctly
Correctly connect micro M1
Intermittent power on the micro M1
line
Restore continuous power to the
micro M1 line
Micro M1 cam not adjusted correctly
Correctly adjust the micro M1 cam
Micro M1 broken
Replace the micro M1
The platform does not close
Lowering valve screw not tight
Close the lowering valve
Pressure switch not correctly
calibrated
Correctly calibrate the pressure
switch
Lowering valve broken
Replace the lowering valve
Electro-pump remote switch broken
Replace the electro-pump remote
switch
Electro-pump broken
Replace the electro-pump
Push-button panel broken
Replace the push-button panel
Electronic control unit broken
Replace the electronic control unit
The platform does not close
completely
Pressure switch not correctly
calibrated
Correctly calibrate the pressure
switch
Max. speed not correctly calibrated
Recalibrate the max. speed