EasyManua.ls Logo

Automatic Technology GDO-6 EasyRoller - User Manual

Automatic Technology GDO-6 EasyRoller
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Home Owner’s Manual
Doc #: 160005_01
Part #: 13368
Released: 05/0314
GDO-6 EasyRoller
®
Roll Up Garage Door Opener
GDO-6 EasyRoller
®

Table of Contents

Other manuals for Automatic Technology GDO-6 EasyRoller

Preview: Installation Instructions
Installation Instructions2 pages

Questions and Answers

  • A
    April LambertAug 23, 2025
    Why is my Automatic Technology GDO-6 EasyRoller not working from the transmitter?
    • V
      veronica33Aug 23, 2025
      If your Automatic Technology Garage Door Opener doesn't work when using the transmitter, here are a few things to check: * Make sure the garage door itself is in good working order. Broken springs, for example, can cause issues. Check the door's operation. * Ensure the opener is getting power by plugging another device of similar voltage into the same power point. * Replace the transmitter battery. * Verify your transmitter uses TrioCode 128 Technology (grey buttons, model number V2). If not, contact your dealer. * Deactivate “Vacation Mode”. * Code the transmitter. * Ensure you're pressing the correct button on the transmitter.
  • N
    Nicholas WarrenSep 4, 2025
    What does it mean if the Open (Green) LED continues to flash on my Automatic Technology Garage Door Opener?
    • E
      Eric SextonSep 5, 2025
      If the Open (Green) LED on your Automatic Technology Garage Door Opener continues to flash, it means the door is obstructed when opening. Clear away any obstructions and test that the door opens correctly. If the door is damaged, contact your door professional.
  • A
    Anthony OwensSep 3, 2025
    Why does one Automatic Technology Garage Door Opener transmitter work, but others don't?
    • J
      Joseph BennettSep 3, 2025
      If one transmitter for your Automatic Technology Garage Door Opener works but the others don't, the issue is likely a faulty transmitter or a flat battery. Try replacing the battery first. If that doesn't work, replace the transmitter.
  • D
    Donna BrooksSep 1, 2025
    What to do if my Automatic Technology GDO-6 EasyRoller door reverses for no apparent reason?
    • P
      pmercadoSep 1, 2025
      If your Automatic Technology Garage Door Opener door reverses for no apparent reason, it might be due to environmental factors such as wind, dust, or extreme temperature changes. Ensure the door runs smoothly before increasing the force pressure. Also, if you have safety beams installed, make sure they are not obstructed and are properly aligned.
  • C
    Charles CarterAug 31, 2025
    Why is the green light flashing on my Automatic Technology GDO-6 EasyRoller?
    • J
      Jacqueline CooperAug 31, 2025
      If the Open (Green) LED continues to flash on your Automatic Technology Garage Door Opener, it indicates that the door is obstructed when opening. Clear away any obstructions and test that the door opens correctly. If the door is damaged, contact your dealer.
  • H
    Hector WalkerAug 29, 2025
    Why is the red light flashing on my Automatic Technology GDO-6 EasyRoller?
    • R
      Raven NobleAug 29, 2025
      If the Close (Red) LED continues to flash on your Automatic Technology Garage Door Opener, it indicates that the door is obstructed when closing or the limits may be cleared. First, clear away any obstructions and test the door closes correctly. If the door is damaged, contact your dealer. Then, remove all power sources (including the battery backup), wait till all lights are out (10-15 secs), then reconnect power. If the Red LED is still flashing, the limits are not set. Contact dealer immediately and discontinue use.
  • D
    deannamooreAug 27, 2025
    Why does Automatic Technology GDO-6 EasyRoller beep 5 times?
    • M
      Maria CruzAug 28, 2025
      The reason your Automatic Technology Garage Door Opener is beeping 5 times and the courtesy light flashes after each operation is because the opener has reached the recommended number of cycles before servicing. Contact your dealer and arrange a door service or press the SET button once to reset the service counter.
  • W
    whiterodneyAug 26, 2025
    What to do if Automatic Technology Garage Door Opener door reverses?
    • S
      Stephen RodriguezAug 27, 2025
      If your Automatic Technology Garage Door Opener door reverses for no apparent reason, it may occasionally occur due to environmental conditions such as windy or dusty areas, or extreme temperature changes. In this case, put the door into manual and contact your dealer. Also, if safety beams are installed, they may be partially obstructed. Ensure the beam path is not obstructed and if the issue continues, contact your dealer.
  • E
    Edward WilliamsAug 25, 2025
    What to do if my Automatic Technology Garage Door Opener doesn't work from transmitter or operate button?
    • V
      Vanessa FinleyAug 25, 2025
      If your Automatic Technology Garage Door Opener door doesn't work from either the transmitter or the operate button, the opener might be disengaged. To solve this, re-engage the opener.

Summary

Safety Rules

Operating Your Door

Transmitter Operation

User Operating Controls

Manual Release; Security

Manual Door Operation

Procedure for disengaging the opener to manually operate the door.

Power Failure

Re-Engaging the Opener

Steps to re-connect the opener after manual operation.

Security - Inbuilt Locking Facility

Safety Testing

Test the Close Cycle

Procedure to test the auto-reverse safety feature during closing.

Testing the Open Cycle

Procedure to test the door stopping mechanism during opening.

Test the Manual Door Operation

Check for smooth manual operation and required force.

Coding Transmitters

Setting Transmitter to Operate Door

Procedure to program transmitter buttons for door control.

Setting Transmitter for Vacation Mode

Erase Programmed Codes

Remotely Coding Transmitters

Troubleshooting Guide

Opener Not Working From Transmitter

Diagnosing issues when the transmitter fails to operate the opener.

SERVICE LED Flashing and Beeping

Interpreting service fault indicators on the opener.

Door Reverses for No Apparent Reason

Troubleshooting unexpected door reversal during operation.

Open;Close LEDs Flashing Alternately

Door Opens But Will Not Close

Diagnosing issues when the door fails to close properly.

Door Stops;Moves Slowly on Battery

Troubleshooting slow operation when using battery backup.

Transmitter Range Issues

Door Maintenance

Opener Maintenance

Service Indicator Function

Warranty

Service Schedule

Automatic Technology GDO-6 EasyRoller Specifications

General IconGeneral
BrandAutomatic Technology
ModelGDO-6 EasyRoller
CategoryGarage Door Opener
LanguageEnglish

Related product manuals