Automatic Technology TEMPO ATS-2V3 - Auto-Close and Accessories; Configure Auto-Close Mode

ATS Series Installation Manual14
14. Auto-Close & Accessories
WARNING! It is compulsory to have
Safety Beams installed when using
Auto-Close mode.
14.1 Auto-Close
Auto-Close mode is a function that automatically closes the door after a pre-set time. Safety beams must be installed in order
to run the Auto-Close function. There are two types of Auto-Close available:
Parameter
Value options = Indicated by brightness
of main light
1 2 3 4 5 6
PE AUTO-CLOSE x2 OFF 15sec 30sec 60sec 90sec -
AUTO-CLOSE x3
OFF 15sec 30sec 60sec 90sec 120sec
i. Standard auto-close - the door will Auto-Close after a programmed time. In this mode the timer starts to countdown as
soon as the door is fully open. This function is useful in case the safety beam does not get triggered.
NOTE: Auto-Close will not function if the door reversed after hitting an obstruction or stalling.
ii. Safety Beam triggered auto-close - the door will auto-close after a programmed time. In this mode the timer starts
counting down only when the safety beam is triggered. ie car leaving the garage.
STEP ONE
STEP TWO
Remove controls
cover
till gear LED
ashing
Press
repeatedly
TO ENABLE THE AUTO-CLOSE FUNCTION
until gear LED
ashes
x 2 PE Auto
x 3 Std Auto
STEP FOUR
STEP THREE
Press to enter
parameter
Default setting for
Auto-Close is OFF.
Press to move through
options as per table
Press to save
OR
Press to leave
unchanged
Press
repeatedly
STEP ONE
STEP TWO
Remove controls
cover
till gear LED
ashing
Press
repeatedly
TO ENABLE THE AUTO-CLOSE FUNCTION
until gear LED
ashes
x 2 PE Auto
x 3 Std Auto
STEP FOUR
STEP THREE
Press to enter
parameter
Default setting for
Auto-Close is OFF.
Press to move through
options as per table
Press to save
OR
Press to leave
unchanged
Press
repeatedly