Automatic Technology TEMPO ATS-2V3 - Setting Limits via Transmitter

ATS Series Installation Manual28
F - Setting Limits via Transmitter
STEP ONE
The SPEED setting on the opener CAN NOT be
adjusted when setting limits via the transmitter.
Follow section 12.1 to set limits and adjust speed.
STEP TWO
Switch power on
tip
SETTING LIMITS VIA TRANSMITTER
+
BLUE LED will ash
& gear LED lit
Remove controls cover
till remote
LED lit
Press
repeatedly
STEP THREE
HOLD
Opener
ashes &
beeps
HOLD for 3 sec
HOLD for 3 sec
RELEASE
Release both
buttons
Then ret
controls cover
STEP ONE
CLOSE LIMIT POSITION
STEP TWO
HOLD
When door near
close, single
presses inch door
CLOSE limit should be
when rubber strip touches
the ground
to Close
STEP THREE
WARNING!
In setting the close limit position,
do not force the door into the oor with
excessive force, as this can interfere with the
ease of operation of the manual release
mechanism.
If door overshoots
Press to Open
Press to Close
position
Press to set
Button 4 is factory coded
to CLOSE function.
Button 2 is factory
coded to SET function
STEP ONE
OPEN LIMIT POSITION
HOLD
to Open
Button 1 is factory coded
to OPEN function.
When door near
open, single
presses inch door
OPEN limit should be the
height of the garage
opening
STEP TWO
WARNING!
The door will automatically close.
open and close again after the next step.
Ensure that nothing is in the door’s path.
STEP THREE
If door overshoots
Press to Close
Press to Open
position
Press to set