Motor Base RPM, 4–10
Motor Maximum RPM, 4–10
Motor Nameplate Amps, 4–9
Motor Nameplate Voltage, 4–9
Multi-function Input Terminals, 4–20
Multi-function Output Terminals, 4–27
Multi-speed bits, 4–37
Over-current Stall Prevention during
Operation, 4–41
Over-current Stall Prevention
duringAcceleration, 4–41
Over-Torque Detection Level, 4–40
Over-Torque Detection Mode, 4–40
Over-Torque Detection Time, 4–40
Over-Voltage Trip Prevention, 4–39
Parameter Lock, 4–47
Present Fault Record, 4–44
PWM Carrier Frequency, 4–19
Restore to Default, 4–47
Reverse Operation Inhibit, 4–38
RS485 Speed Reference, 4–49
RUN Command, 4–49
Select method for 2nd Accel/Decel, 4–14
Skip Frequencies , 4–15
Skip Frequency Band, 4–15
Slip Compensation, 4–18
Source of Frequency Command, 4–29
Source of Operation Command, 4–20
Stop Methods, 4–11
summary, 4–2
Time Out Detection, 4–47
Time Out Duration, 4–47
Transmission Fault Treatment, 4–47
Transmission Speed, 4–46
Upper Bound of Output Frequency, 4–43
User Defined Display Function, 4–45
Volts/Hertz, 4–17
PLC Module Connections, B–6
PLC Modules, B–2
Potentiometer, 3–2
Present Fault Record, 4–44
Preset Parameters, 4–37
Programming, 3–4
Protection Parameters, 4–38
PWM Carrier Frequency, 4–19
Q
Quickstart, 3–5
R
Ramp Parameters, 4–11
Reset faults, 4–49
Restore to Default, 4–47
Reverse Operation Inhibit, 4–38
RS485 Speed Reference, 4–49
RUN Command, 4–49, 5–13
S
Select method for 2nd Accel/Decel, 4–14
Skip Frequencies , 4–15
Skip Frequency Band, 4–15
Slip Compensation, 4–18
Source of Frequency Command, 4–29
Source of Operation Command, 4–20
Specifications, 1–5
Status Addresses, 5–4
Status Display, 3–3
Status Monitor, 5–4
Stop Command, 5–13
Stop Methods, 4–11
Supplemental Publications, 1–2
T
Technical Support, 1–2
Time Out Detection, 4–47
Time Out Duration, 4–47
Transmission Fault Treatment, 4–47
Troubleshooting, 6–3
Index
GS1 Series AC Drive User Manual
i–4
To Next Page
Loading...
Need help?
General
