Chapter 4: AC Drive Parameters
GS1 Series AC Drive User Manual
4–2
GS1 Parameter Summary
Parameter can be set during RUN Mode.
Motor Parameters
GS1
Parameter
Description Range Default
0-00
Motor Nameplate Voltage 200/208/220/230/240 240
0-01
Motor Nameplate Amps Drive Rated Amps X .3 to 1.0
Drive Rated
Amps X 1.0
0-02
Motor Base Frequency 50/60/400 60
0-03
Motor Base RPM 375 to 9999 RPM 1750
0-04
Motor Maximum RPM 0-03 to 9999 RPM 0-03
Ramps
1-00
Stop Methods
0: Ramp to Stop
1: Coast to Stop
0
1-01
Acceleration Time 1 0.1 to 600.0 sec 10.0
1-02
Deceleration Time 1 0.1 to 600.0 sec 30.0
1-03
Accel S-curve 0 to 7 0
1-04
Decel S-curve 0 to 7 0
1-05
Acceleration Time 2 0.1 to 600.0 sec 10.0
1-06
Deceleration Time 2 0.1 to 600.0 sec 30.0
1-07
Select method to use
2nd Accel/Decel
0: RMP2 from terminal
1: Transition Frequencies
P1.08 & P1.09
0
1-08
Accel 1 to Accel 2
frequency transition
0.0 to 400.0 Hz 0.0
1-09
Decel 1 to Decel 2
frequency transition
0.0 to 400.0 Hz 0.0
1-10
Skip Frequency 1 0.0 to 400.0 Hz 0.0
1-11
Skip Frequency 2 0.0 to 400.0 Hz 0.0
1-12
Skip Frequency 3 0.0 to 400.0 Hz 0.0
1-17
Skip Frequency Band 0.0 to 20.0 Hz 0.0
1-19
DC Injection Voltage Level 0 to 30% 0
1-20
DC Injection during Start-up 0.0 to 5.0 sec 0.0
1-21
DC Injection during Stopping 0.0 to 25.0 sec 0.0
1-22
Start-point for DC Injection 0.0 to 60.0 Hz 0.0
To Next Page
Loading...
Need help?
General
