AutomationDirect CLICK PLUS PLC User Manual

Step 4: Create a Project (cont’d)
Rung #2
Place the Box Cursor at the beginning of Rung #2. From the Instruction List, click and drag a
Contact (NO) into this box. Enter T1 into the Bit Memory Address text box of the Contact
Normally Open dialog box that pops up. Click OK. A normally open contact labeled T1 will
be placed in the beginning of Rung #2.
Next, place the Box Cursor on the NOP coil at the far right of Rung #2. Click and drag an
OUT from the Instruction List into this location. Within the Out dialog box, enter Y001 into
the Bit Memory Address: text box. Click OK. An out coil labeled Y001 will be placed at the
end of Rung #2.
Rung #3
Finally, place the Box Cursor on the NOP coil at the far right of Rung #3. Click and drag an
END from the Instruction List into this location. An END instruction indicates the last part
of the main ladder logic program. You have created your rst project!
CLICK PLUS PLC Hardware User Manual, 1st Edition, Rev. K – C2-USER-M
1-14
Chapter 1: Getting Started

AutomationDirect CLICK PLUS PLC Specifications

General

Brand	AutomationDirect
Model	CLICK PLUS PLC
Category	Controller
Language	English