Table of Contents
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. E, 021105,
Autronica Fire and Security AS
Page 2
4.
About «In the Event of….» ..............................................30
5.
In the Event of a Fire Alarm ............................................32
5.1
Indications in the Event of a Fire Alarm............................................. 32
5.2
Actions to be Taken in the Event of a Fire Alarm .............................. 33
6.
In the Event of a Fire Alarm - with Alarm Delay...........36
6.1
Indications - Fire Alarm with Alarm Delay.......................................... 36
6.2
Actions to be Taken - Fire Alarm with Alarm Delay........................... 37
7.
In the Event of a Fire Warning ........................................40
7.1
Indications in the Event of a Fire Warning......................................... 40
7.2
Actions to be Taken in the Event of a Fire Warning.......................... 41
8.
In the Event of Faults ......................................................43
8.1
Indications in the Event of Faults....................................................... 43
8.2
Actions to be Taken in the Event of Faults........................................ 44
9.
Menu Mode.......................................................................46
9.1
How to Enter Menu Mode.................................................................. 46
9.2
The Menu Mode Display.................................................................... 46
9.3
Buttons Used to Operate the Menu................................................... 47
9.4
Action Digits in Menu Mode............................................................... 47
9.4.1
Introduction.............................................................................. 47
9.4.2
Action Digits Table .................................................................. 47
9.5
How to Operate in Menu Mode.......................................................... 48
9.6
Example - How to Disable Detection Zones ...................................... 48
9.6.1
Using the Keyboard to Enter Text into the Input Field............. 49
9.6.2
Using the Up/Down Arrows in the Selection Field................... 50
10.
Show Status .....................................................................52
10.1
Introduction........................................................................................ 52
10.2
Show Status Menu ............................................................................ 52
10.3
Show Status - Fire Alarms................................................................. 53
10.4
Show Status – Fire Warnings............................................................ 54
10.5
Show Status - Faults ......................................................................... 55
10.6
Show Status - Disablements ............................................................. 56
10.7
Show Status - Detection Zones in Test ............................................. 58
10.8
Show Status – Oil & Gas Inhibited Points ......................................... 59
10.9
Show Status – Activated Outputs ...................................................... 60
11.
Disabling ..........................................................................62
11.1
General.............................................................................................. 62
11.2
Disable Menu..................................................................................... 62
11.3
Indications on the Operator Panel ..................................................... 63
11.4
Disabling Activated / Deactivated Components................................. 63
11.5
Disabling Detection Zones................................................................. 63
11.6
Disabling Points................................................................................. 64
11.7
Disabling Fire Alarm Devices ............................................................ 64
To Next Page
Loading...
