Autronica BS-320 - 11.6 Disabling Points; 11.7 Disabling Fire Alarm Devices; 11.8 Disabling Fire Alarm Routing Equipment; 11.9 Disabling Outputs

Disabling
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. E, 021105,
Autronica Fire and Security AS
Page 62
11. Disabling
11.1 General
From the Disable menu you can disable the following:
• Detection Zones
• Points (fire detectors, manual call points)
• Fire Alarm Devices (FAD)
• Fire Alarm Routing Equipment (FARE)
• Outputs
• Fault Warning Routing Equipment (FWRE)
• Immediate Output Actioning
When disabling components, a disablement time is given. The
disablement time can be increased for already disabled components
by entering the disable menu.
For information on Disablement Sources, refer to chapter 3.14.
11.2 Disable Menu
Select Single Unit
Select disablement time
Fire Alarm Devices
Select FARE
Select disablement time
Fire Alarm Routing Equipment
Select DZ
Select disablement time
Detection Zones
Select Point
Select disablement time
Points
Disable
Immediate Output Actioning
Select Single Output
Select All in Operation Zone
Outputs
Fault Warning Routing Equipment
Select FWRE
Select disablement time
Select All Areas
Select Specific Area
Select All in Alarm Zone
Select disablement time
Select Single Output
Select Single Unit
Select disablement time
Fire Alarm Devices
Select FARE
Select disablement time
Fire Alarm Routing Equipment
Select DZ
Select disablement time
Detection Zones
Select Point
Select disablement time
Points
Disable
Immediate Output Actioning
Select Single Output
Select All in Operation Zone
Outputs
Fault Warning Routing Equipment
Select FWRE
Select disablement time
Select All Areas
Select Specific Area
Select All in Alarm Zone
Select disablement time
Select Single Output
Figure 11-1: Disable Menu.
www.ukpanels.com