Autronica BS-320 - 13. System Menu; 13.1 Introduction; 13.2 System Menu

Enabling
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. E, 021105,
Autronica Fire and Security AS
Page 71
12.11 How to Execute Commands from the
Enable Menu
The example below shows how to enable a Detection Zone. The
similar procedure applies to all other selections (1-7).
Step Actions to be taken Display Indication
1
To enter the Main Menu, press
!
MENU
19:23
Total: 3
1 SHOW STATUS
2 DISABLE
3 ENABLE
4 SYSTEM
5 SERVICE
2
To select ENABLE, press 3.
ENABLE
1 DETECTION ZONES
2 POINTS
3 FIRE ALARM DEVICES
4 FIRE ALARM ROUTING EQUIPMENT
5 OUTPUTS
6 FAULT WARNING ROUTING EQUIPMENT
7 IMMEDIATE OUTPUT ACTIONING
19:23
ENABLE
1 DETECTION ZONES
2 POINTS
3 FIRE ALARM DEVICES
4 FIRE ALARM ROUTING EQUIPMENT
5 OUTPUTS
6 FAULT WARNING ROUTING EQUIPMENT
7 IMMEDIATE OUTPUT ACTIONING
19:23
3
To select, press the relevant number, in this
example 1 (DETECTION ZONES).
4
Use the keyboard to enter text into the input box
-
OR ,- as shown in this example:
press
then move the cursor to the desired selection
(OFFICES) by scrolling with the arrow buttons
6
PQR
or
9
YZ
ENABLE
19:23
KITCHEN
CANTEEN
OFFICES
WORKSHOP
DETECTION ZONES
ENABLE
19:23
KITCHEN
CANTEEN
OFFICES
WORKSHOP
DETECTION ZONES
ENABLE
19:23
DETECTION ZONES
KITCHEN
CANTEEN
OFFICES
WORKSHOP
ENABLE
19:23
DETECTION ZONES
KITCHEN
CANTEEN
OFFICES
WORKSHOP
www.ukpanels.com