Autronica BS-320 - 12.7 Enabling Fire Alarm Routing Equipment; 12.8 Enabling Outputs; 12.9 Enabling Fault Warning Routing Equipment; 12.10 Enabling Immediate Output Actioning

To Next Page

To Previous Page

Enabling

Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. E, 021105,

Autronica Fire and Security AS

Page 68

12. Enabling

12.1 General

From the Enable menu you can enable the following:

• Detection Zones

• Points (fire detectors, manual call points)

• Fire Alarm Devices (FAD)

• Fire Alarm Routing Equipment (FARE)

• Outputs

• Fault Warning Routing Equipment (FWRE)

• Immediate Output Actioning

12.2 Enable Menu

Select Single Unit

Fire Alarm Devices

Select FARE

Fire Alarm Routing Equipment

Select DZ

Detection Zones

Select Point

Points

Enable

Immediate Output Actioning

Select Single Output

Outputs

Fault Warning Routing Equipment

Select FWRE

Select All Areas

Select Specific Area

Select All in Alarm Zone

All in Operation Zone