AUX DC Inverter Free Match 50HZ R32
169
◇If there are many points to be welded ,please set a filter in the pipe(buy from local market)
◇Please use nitrogen gas or air to remove the dust and water in the pipe,
◇Please lay out the piping according to the tend towards of the piping, but it is not allowed
more than 3 times curved at the same point of the pipe(if do like this the pipe will become rigid)
◇When using pipe bending machine, the curvature shall not be too small or it will affect the
refrigerant flow.
To Next Page
Loading...
