AUX DC Inverter Free Match 50HZ R32
2. Parameters Setting
Indoor unit’s parameters can be set by remote controller (YK-L) and wired remote
controller—For after-sales (In indoor side ,After a new PCB was replaced, indoor parameters set
is necessary).
2.1 Parameter Setting table
Note:
【04】：Model of IDU
【05】：Capacity of IDU，
【15】：Selection of air return temperature sensor; 00 – sensor in indoor unit , 01—Sensor in
wired controller
2.2 Parameter Setting by YK-L
Enter the setting interface
① Make sure the remote controller is off
② Press the two white button at the down side simultaneously more than 10s to enter the
To Next Page
Loading...
