AUX AMWM-H09/4R3 - Parameter Checking; Parameter Setting by XK-04; XK-05

AUX DC Inverter Free Match 50HZ R32
2.3 Parameter Setting by XK-04/ XK-05
Parameter checking
Press the “FUNCTION” button for 5 seconds, enter into the parameter checking interface .
the wired controller’s address will be displayed in the temperature zone of LED screen
( press “FUNCTON” button, the wired controller’s address will flash, the wired controller ‘s
address can be changed through press the“ ”or“ ”, then press “FUNCTION” buton to
confirm);
In the timing setting zone :HH means seires NO. MM means parameter value. After
Entering into IDU parameter checking , via pressing the“ ”or“ ”buton ,you can check
the parameter value of seires NO.【04】【05】【1】.
Parameter setting
Only in parameter checking model ,press the “FUNCTION” button for 5 seconds,
Enter into parameter setting model.
1. Press “FUNCTION” for 5S , enter parmater checking
2. Press “ ”or“ , change the parameter value
of seires NO.
HH: means seires NO.
MM: means parameter value.