AVANT 744i - Load Indicator

Lift capacity Avant 755i 760i
42
.
Load indicator
The loader is equipped with a load sensor system.
When tipping load is being approached, the system
gives an audible warning signal and a red indicator
lights up in the dashboard. This means that the rear
wheels of the loader are about to lose contact with
the ground on level ground.
When the warning is given, the loader could easily tip
forward because of movements of the loader boom,
acceleration or deceleration, steering of the loader,
or uneven ground surface.
Read the safety instructions regarding handling of
heavier loads, see page 87.
The load sensor must be calibrated if counterweights
are added or removed. The sensor must also be
calibrated at least annually. Calibration instructions
for the load sensor system can be found on page
123.
.
WARNING
Risk of tipping over -
Observe
the load indicator warning.
When
the load indicator warning is
triggered, there is high risk that the
loader will start tipping forward.
Lower the load in a calm manner
and avoid abrupt movements.
Keep loads as close to the gr
ound
as possible during driving an
d lift
after stopping the loader first. Keep
telescopic boom retracted. Never
lift the boom or extend telescopic
boom if warning is triggered.
The load indicator is an additional
device that does not remove the
responsibil
ity of the operator to
operate the
loader in a safe
manner.