AVANT 744i - Working with Attachments; Attachment Requirements and Compatibility

Working with attachments Avant 755i 760i
88
Working with attachments
. ..
Requirements for attachments
Any attachment mounted on the loader must meet applicable safety and technical standards and requirements. An
attachment that is not specifically designed for the loader may cause unnecessary safety risks. Make sure that 755
/ 760 is specifically listed as compatible loader in the operator's manual of the attachment. Some attachments may
require the use of additional special protective guards or personal safety equipment. See the operator's manual of
the attachment.
WARNING
Risk of serious injury -
Always make sure that the attachment is intended to be
used with this loader model.

Read the Op
erator's Manual of the attachment before you begin to install or use any
attachment. Always follow the instructions in the operator's manual of the attachment.

Make sure that the attachment is compatible with the loader: Avant 755 / 760 must be
specificall
y listed in the operator's manual of the attachment. Contact your Avant
dealer if necessary. Incompatible attachments can cause risks of injuries resulting
from eg. the stability of the loader, contact with moving parts, reduced visibility, or
ejected debris.

Use all attachments only for their intended purpose that is described in the Operator's
Manual of the attachment.

Make sure that the attachment is connected properly on the quick coupling plate of
the loader, and as described in the Operator's Manual of the attachment.

Follow all instructions regarding personal protective equipment, safety distances, and
possible additional guards that are needed when operating certain attachments.

Familiarise yourself with the operation and stopping of the attachment a
t a safe
place. Put the attachment down on the ground and switch off the loader before
leaving driver’s seat, and follow possible additional steps for safe shutdown of the
attachment.

Keep attachments in good and safe operating condition. Follow the inspection,
maintenance, and service instructions of the attachment.